fb

IFlogo

Dublin: +353 1 626 8363
Cork : +353 21 439 7313
N. Ireland: +44 28 7187 8753

The Provinces Range of Modular Railings are Highly Price Competitive and Offer a Huge Range of Designs

We recognise that  cost is an important factor in any construction project and we have developed a range of modular designs using hollow section tubing instead of the solids used in our other railing designs. We call these our Provinces Ranges.

A recent project we completed was at Calor Gas on the Longmile Road

Irfen® Super System Range

We have developed this range of railings based on our years of experience with our Leinster Munster and Ulster System Railings which have been widely used for the past 20 years in Industrial Educational Housing and Domestic projects. The basic design can be enhanced by the addition of Spearheads, Bosses and Collars from the Irfen® Wrought Iron Range.

Drawings & Specifications

Leinster Railing

Leinster railings have punched flat bar top and bottom rails The infills are 20 x 20mm box section. The tops of the bars can be plain angle cut or crush pointed. The panels are supported on posts of steel box section, round tube or RSJ of various sizes. A number of heights with standard panel lengths are available.

Drawings & Specifications

Munster Railings

Munster railings are similar in design to Leinster and have punched flat bar top and bottom rails but incorporating rings and additional top rail. The infills are 20 x 20mm box section. The tops of the bars can be plain angle cut or crush pointed. The panels are supported on posts of steel box section, round tube or RSJ of various sizes.

Drawings & Specifications

Ulster Railing

Ulster railings have punched flat bar top and bottom rails The infills are 25mm OD. round tube. The tops of the bars have a choice of three top designs; angle top, square top, or the decorative Elite top. The panels are supported on posts of steel box section, round tube or RSJ of various sizes. A limited number of heights are available.

Drawings & Specifications

Connaught Railing

Connaught railings are similar in design to Leinster but utilizing heavier 25 x 25 mm Box Section Tube in a Diamond profile and a 50 x 25mm rail with a choice of 4 different top finishes “Blunt, Angled , Elite and Dart.” The panels are supported on posts of steel box section, round tube or RSJ of various sizes. A number of heights with standard panel lengths are available.

Drawings & Specifications

IF-Railings-Brochure

Gates are available integrated in all of our railings systems.

Kinsale-Security-Mesh-and-Inova-Sliding-Gate-Belfast-Health-Centre-Mica-Drive-Belfast

We provide quality gates both manual and automated in Swing, Slide or Cantilever designs. All Automated gates will be installed by PSA (Private Security Authority) Licenced personnel where this is legally required, and will be CE marked for your assurance and safety. In accordance with Irish Health and Safety requirements.

We can match all our standard fence and railing products or customise to your requirements

Quality finishes in a wide range of Colours

colorwheel

All our products have a base finish of Full Hot Dipped Galvanising to I.S. EN ISO 1461: 2009  a Polyester coating to BS EN 13438: 2005 & BS 1722-16: 2009 can also be applied over this to give a Plasgalv™  finish.

Standard Colours are Green, Black, Grey. Other colours From The RAL range can cost extra depending on the quantity required.

Check the information on Finishing and Protective coatings here..

    Upload a Photo, Drawing, Document or Zip Archive (8mb Max.)